Fault management testing is required to validate the effective
event handling of the manager application. This is achieved through
Trap simulation in SNMP devices. The Network Designer tool and the
SNMP Agent Simulator offers an intuitive trap and inform configuration
wizard, to configure and generate any number of traps/informs from
a device, under different scenarios. This helps demonstrating and
testing an application's handling of trap traffic under different
conditions.
Further, the toolkit offers the Trap Stormer, an exclusive tool
to storm SNMPv1/v2c traps at burst and normal modes. Trap storms
can be generated to validate the effective event handling of the
manager application.
Trap and Inform Simulation wizard
Request-based traps and informs can be configured to be generated
when a Get/Get-Next/Set request is made on a variable.
Threshold-based traps and informs can be configured to be generated
when a threshold condition is satisfied.
Timer-based traps and informs can be configured to be sent on
a daily or periodical basis, at the specified time.
Option to Enable/disable SNMP Trap and Inform Service.
Trap Simulation wizard
Inform Simulation wizard
SNMP Trap Stormer Tool
Configure to send any number of traps at the specified time-interval
or at the burst mode, without specifying the time-interval.
Configure multiple "Agent IP Address" for each trap.
Capable of sending a maximum of 1800 v1/v2 traps per second
in the burst mode with 4 varbinds and 400 traps per second with
2 varbinds in the normal mode, in Linux OS with 2.4 GHz.
