Menu bar

The Following menus are available in Configuration Application.

Main Menus

File Menu

The File menu has the following functions.

File Menu

Load - To load the TaskList, an XML file that can be used to generate configuration commands.
Unload - To unload the TaskList file from the Config Tree.
Save - To save the current default values into specified default file.
Exit - To quit from Configuration Application.

Task Menu

The Task menu has the following functions.

Add - To add a configuration task.
Delete - To delete a configuration task.
Modify - To modify a configuration task.

Operations Menu

The Operations menu has the following functions.

Connect - To make a connection with specified device.
Disconnect - To disconnect the device from the Config Application.
Telnet to Device - To connect the device remotely.
Clear - To clear the response message box.
Prompt Action Table - To support multiple prompts while receiving the response from device.
Issue Show Command - To issue a show command to receive the system information. You can send show commands immediately after connecting the device in user mode where as to send in Enable mode you need an authorization in configure the device.

Configuration Menu

Run - To run the wizards or tasks.

Help Menu

Contents - This shows the WebNMS CLI API documentation.
About - This shows the about screen of Configuration Application.

Pop-up Menus

Apart from the main menus, Configuration Application also has pop up menus that pop-up in Tree panel. These menus pop up on right-click of the mouse button in any task listed in the ConfigTree.

Add - To add a configuration task.

Delete - To delete a configuration task.

Modify - To modify a configuration task.